PC8 firmware: news - novità

🇺🇸 This forum ONLY contains issues related to the PC8 Firmware 2.5.x
🇮🇹 Questo forum contiene SOLO problematiche relative al firmware 2.5.x del PowerControl8
User avatar
SwRnBk
Posts: 18
Joined: Mon Feb 13, 2017 12:49 pm

Re: PC8 firmware: news - novità

Post by SwRnBk »

everything here works grate so far, including TP Upload
You do not have the required permissions to view the files attached to this post.
User avatar
Tillquist
Posts: 108
Joined: Mon Feb 13, 2017 6:13 am
Location: Denmark
Contact:

Re: PC8 firmware: news - novità

Post by Tillquist »

The altimeter is not working as it should with 2.5.4

I have been on a training run 324 meters in altitude and my PC8 shows 0 meters

I would add fit the file from today, but the type of file is not allowed to add.

Image
Image
D e n m a r k

Use Image with Power2max Type-S and Power2max NG power meter.
amesser325
Posts: 11
Joined: Mon Feb 13, 2017 12:20 am

Re: PC8 firmware: news - novità

Post by amesser325 »

Running Firmware 2.5.4, it took about 20 min to acquire GPS signal on a sunny day. Typical is 2-3 min. For what it's worth I used a different profile yesterday that has GPS turned off. I ended up stopping to see if that helped. I could not remember the procedure for GPS reset so I just gave up. As I looked down when rolling out from the stop I noticed it had acquired signal and stayed that way the rest of the ride.

When reviewing the ride via Today's Plan it showed negative altitude for the period when it hadn't acquired signal then back to normal once locked. I referred back to yesterday's trainer/no GPS ride and saw it had a 40ft decay in altitude over the course of the ride (~1:20h). I was in my basement and in the past it has occasionally been able to acquire a GPS signal though typically it can't lock and pops up with the option to continue searching or stop.

I'll keep my eye on it over the next several rides and report back with any issues.

Thanks,

Andy
eduriz
Posts: 55
Joined: Mon Feb 13, 2017 10:01 am

Re: PC8 firmware: news - novità

Post by eduriz »

simone wrote: Thu Feb 23, 2017 5:07 pm
eduriz wrote: Thu Feb 23, 2017 1:10 pm update del firmware a 2.5.3 fatto.
Ho avuto alcuni problemi con il sensore Cardio. Non lo riconosceva più. Entrato fatto pairing e poi x i primi 20-25min la frequenza era sempre su 240-250 poi ha iniziato a funzionare!
Il resto tutto ok upload via wifi ecc. no problem!
allego file screenshoot il .fit file non lo posso allegare non mi lascia
cia
edi
Ciao, strano. Tienilo sotto occhio per favore e facci sapere. Potrebbe anche essere la fascia.
Ciao ho riprovato ma questi giorni sempre avuto di nuovo problemi con il sensore cardio. X escludere che sia la facia ho portato dietra anche un garmin 820 e li non avevo nessun problema. Veniva rilevata subito e senza sbalzi.
Oggi ho installato il FirmWare 2.5.4 e ti darò info se cambia qualcosa!
ciao
edi
User avatar
simone
Site Admin
Posts: 1969
Joined: Fri Feb 10, 2017 12:21 am
Location: Lucca
Contact:

Re: PC8 firmware: news - novità

Post by simone »

eduriz wrote: Mon Feb 27, 2017 6:34 am
simone wrote: Thu Feb 23, 2017 5:07 pm
eduriz wrote: Thu Feb 23, 2017 1:10 pm update del firmware a 2.5.3 fatto.
Ho avuto alcuni problemi con il sensore Cardio. Non lo riconosceva più. Entrato fatto pairing e poi x i primi 20-25min la frequenza era sempre su 240-250 poi ha iniziato a funzionare!
Il resto tutto ok upload via wifi ecc. no problem!
allego file screenshoot il .fit file non lo posso allegare non mi lascia
cia
edi
Ciao, strano. Tienilo sotto occhio per favore e facci sapere. Potrebbe anche essere la fascia.
Ciao ho riprovato ma questi giorni sempre avuto di nuovo problemi con il sensore cardio. X escludere che sia la facia ho portato dietra anche un garmin 820 e li non avevo nessun problema. Veniva rilevata subito e senza sbalzi.
Oggi ho installato il FirmWare 2.5.4 e ti darò info se cambia qualcosa!
ciao
edi
Perfetto!
Ing. Simone Stilli
Responsabile SRM Italia - Software Developer

Image

Image
User avatar
simone
Site Admin
Posts: 1969
Joined: Fri Feb 10, 2017 12:21 am
Location: Lucca
Contact:

Re: PC8 firmware: news - novità

Post by simone »

Tillquist wrote: Sun Feb 26, 2017 4:08 pm The altimeter is not working as it should with 2.5.4

I have been on a training run 324 meters in altitude and my PC8 shows 0 meters

I would add fit the file from today, but the type of file is not allowed to add.

Image
Please go in ant debug and check the pressure/temperature
Ing. Simone Stilli
Responsabile SRM Italia - Software Developer

Image

Image
User avatar
simone
Site Admin
Posts: 1969
Joined: Fri Feb 10, 2017 12:21 am
Location: Lucca
Contact:

Re: PC8 firmware: news - novità

Post by simone »

amesser325 wrote: Mon Feb 27, 2017 2:42 am Running Firmware 2.5.4, it took about 20 min to acquire GPS signal on a sunny day. Typical is 2-3 min. For what it's worth I used a different profile yesterday that has GPS turned off. I ended up stopping to see if that helped. I could not remember the procedure for GPS reset so I just gave up. As I looked down when rolling out from the stop I noticed it had acquired signal and stayed that way the rest of the ride.

When reviewing the ride via Today's Plan it showed negative altitude for the period when it hadn't acquired signal then back to normal once locked. I referred back to yesterday's trainer/no GPS ride and saw it had a 40ft decay in altitude over the course of the ride (~1:20h). I was in my basement and in the past it has occasionally been able to acquire a GPS signal though typically it can't lock and pops up with the option to continue searching or stop.

I'll keep my eye on it over the next several rides and report back with any issues.

Thanks,

Andy
Thanks! Let us know.
Ing. Simone Stilli
Responsabile SRM Italia - Software Developer

Image

Image
User avatar
simone
Site Admin
Posts: 1969
Joined: Fri Feb 10, 2017 12:21 am
Location: Lucca
Contact:

Re: PC8 firmware: news - novità

Post by simone »

Roberto wrote: Tue Feb 21, 2017 8:34 pm Ciao Simone,

installata la versione 2.5.2:
1) GPS ora sembra che vada, comunque è molto lento e impiega molti minuti prima di prendere nonostante che ho fatto azzeramento come da procedura. Domani test su strada.
2) Non riesco già dal primo aggiornamento a fare login per consenso a scaricare in Facebook, clicco su accedi dopo avere messo User e Password non succede nulla rimane li bloccato, TrainingPeacks da errore ed ora non riesco da PC8 a mettere NO rimane su SI, Twitter da errore, Ok Strava, Ok iMail.
Ciao,
hai provato a mettere il firmware 2.5.4 (ti abbiamo mandato email)?
Per il resto assicurati di avere i nomi utente e password giusti. Vedo che la gente fa upload quindi significa che riescono a prendere i token.
Ing. Simone Stilli
Responsabile SRM Italia - Software Developer

Image

Image
eduriz
Posts: 55
Joined: Mon Feb 13, 2017 10:01 am

Re: PC8 firmware: news - novità

Post by eduriz »

simone wrote: Mon Feb 27, 2017 7:05 am
eduriz wrote: Mon Feb 27, 2017 6:34 am
simone wrote: Thu Feb 23, 2017 5:07 pm
Ciao, strano. Tienilo sotto occhio per favore e facci sapere. Potrebbe anche essere la fascia.
Ciao ho riprovato ma questi giorni sempre avuto di nuovo problemi con il sensore cardio. X escludere che sia la facia ho portato dietra anche un garmin 820 e li non avevo nessun problema. Veniva rilevata subito e senza sbalzi.
Oggi ho installato il FirmWare 2.5.4 e ti darò info se cambia qualcosa!
ciao
edi
Perfetto!
Tutto funziona ecetto di nuovo il problema con facia cardio garmin, domani provo con il sensore srm con la stessa fascia e ti farò sapre.
x il resto tutto ok con FW 2.5.4 upload ecc. tutto ok GPS mi sembra piu veloce!
ciao
edi
User avatar
simone
Site Admin
Posts: 1969
Joined: Fri Feb 10, 2017 12:21 am
Location: Lucca
Contact:

Re: PC8 firmware: news - novità

Post by simone »

eduriz wrote: Mon Feb 27, 2017 12:04 pm
simone wrote: Mon Feb 27, 2017 7:05 am
eduriz wrote: Mon Feb 27, 2017 6:34 am

Ciao ho riprovato ma questi giorni sempre avuto di nuovo problemi con il sensore cardio. X escludere che sia la facia ho portato dietra anche un garmin 820 e li non avevo nessun problema. Veniva rilevata subito e senza sbalzi.
Oggi ho installato il FirmWare 2.5.4 e ti darò info se cambia qualcosa!
ciao
edi
Perfetto!
Tutto funziona ecetto di nuovo il problema con facia cardio garmin, domani provo con il sensore srm con la stessa fascia e ti farò sapre.
x il resto tutto ok con FW 2.5.4 upload ecc. tutto ok GPS mi sembra piu veloce!
ciao
edi
bene, hai provato a ricercare la fascia cardio?
E'comunque un problema in studio :-)
Ing. Simone Stilli
Responsabile SRM Italia - Software Developer

Image

Image
Post Reply